Cart

General Information NEW in the Original Packaging Stocked & Shipped From – LEXINGTON, KY What is This Part? This is the Suzuki OEM Transfer Case Lower Shifter Boot Clamp Direct Replacement What Will I Receive? Qty 1 – Clamp, Lower Shifter Boot What Vehicle Will This Fit? Suzuki Samurai       1985 – 1995        All Models Suzuki...

General Information

• NEW in the Original Packaging
• Stocked & Shipped From - LEXINGTON, KY

What is This Part?

• These parts fix the shifting problems with the Transmission Shifter.
• NOTE: The Locating Lever Bolt goes inside the upper transmission housing and guides the shifter’s movement through gear changes. When this bolt gets worn or broken, shifting the gears will become difficult and replacing the bolt will be necessary.
• Includes Lock Washer
• Direct Replacement

What Will I Receive?

• Qty 1 - Lever Locating Bolt (10mm) (small)
• Qty 1 - Lock Washer

What Vehicle Will This Fit?

• Suzuki Samurai       1985 - 1989        All Models
• Suzuki SJ413           1985 - 1989       All Models

General Information

• NEW in the Original Packaging
• Stocked & Shipped From - LEXINGTON, KY

What is This Part?

• This is the Brass Spindle Bush that fits on the inside of the front spindles
• Fits the LH & RH sides
• Direct Replacement OEM Suzuki parts

What Will I Receive?

• Qty 2 - Brass Spindle Bush

What Vehicle Will This Fit?

• Suzuki Samurai          1985 - 1995     All Models
• Suzuki SJ410              1980 - 1984     All Models

General Information NEW in the Original Packaging Stocked & Shipped From – LEXINGTON, KY What is This Part? These are Axle Grease Caps that fit a wide array of Vehicle Make and Models. Made from 1.5mm Thick Steel Cap Shaft is 40mm Wide Cap Flange is 49mm Wide Cap Height is 20mm Direct Replacement What...

General Information NEW in the Original Packaging Stocked & Shipped From – LEXINGTON, KY What is This Part? These are the Suzuki Samurai OEM Flexible Wire Clamps. These are the Original Suzuki Rubber Coated Flex Clamps. Bolt-On Design. Bends to Any Shape Required. Best Clamp Made for Holding Wires and Cables Securely in Place. Doesn’t Damage...

General Information NEW in the Original Packaging Stocked & Shipped From – LEXINGTON, KY What is This Part? This is the Complete Transfer Case Shifter Repair Kit which is the only kit that repairs all aspects of the Transfer Case shifting mechanism. Repairs both the Transfer Case Shift Lever and Shifting Rods. Direct Replacement What...

What is This Part?

• This is the Washer Set for the Front Axle Hub.
• OEM
• Complete for both sides.

 What Will I Receive?

• Qty 2 - Lock Washers
• Qty 2 - Star Washers

What Vehicle Will This Fit?

• Suzuki Samurai      1986 - 1995       All Models
• Suzuki SJ413           1985 - 1995       All Models
• Suzuki SJ410           1980 - 1984       All Models

What is This Part?

• These are the CONE WASHERS that fit onto the Locking Hub Installation Bolts.
• INCLUDES One Full Set of Cone Washers (Does One Locking Hub - RH or LH)
• Direct Replacement

What Will I Receive?

• Qty 6 - Cone Washers (Does One Locking Hub - RH or LH)

What Vehicle Will This Fit?

• Suzuki Samurai       1985 - 1995        All Models
• Suzuki SJ413           1985 - 1995       All Models
• Suzuki SJ410           1980 - 1984       All Models

What is This Part?

• This part is the Suzuki OEM Lug Nut Stud that fits into the Front Rotor and receives the lug nut after the wheel has been mounted.
• It is part number 09119-12008.
• To replace all studs it requires 5 studs per rotor.
• These are for the front wheels only.
• The rear wheels requires stud #09119-12006, which we also sell.
• To purchase that item select the “Wheels/Spare Tire” Category in the far left column.
• NOTE: THESE WHEEL STUDS ARE THE NON-CLIPPED HEAD. The 1986 - 1988 have a clipped head. This changed occurred in the late 88 thru early 89 models so please verify which type you need if you are ordering for an 88' or 89' Samurai. From the 90' model Samurai on to 95’ they were all Non-Clipped.
• ALSO INCLUDED: Lug Nuts for the Front Wheel Studs!

What Will I Receive?

• Qty 10 - Front Studs
• Qty 10 - Lug Nuts

What Vehicle Will This Fit?

• Suzuki Samurai      1985 - 1995       All Models
• Suzuki SJ413           1985 - 1995       All Models

General Information

• NEW in the Original Packaging
• Stocked & Shipped From - LEXINGTON, KY

What is This Part?

• This part is the Lug Nut Stud that fits into the Drum and receives the lug nut after the wheel has been mounted.
• It is part number 09119-12006.
• To replace all studs it requires 5 studs per drum.
• These are for the REAR wheels only.
• The front wheels require a different type stud part #09119-12008, which we also sell. To purchase that item select the “Wheels/Spare Tire” Category in the far left column.
• Note: Color May vary
• Direct Replacement

What Will I Receive?

• Qty 5 - Lug Nut Studs (Rear Wheel)

What Vehicle Will This Fit?

• Suzuki Samurai       1988 - 1995        All Models
• Suzuki SJ413           1988 - 1995       All Models

General Information NEW in the Original Packaging Stocked & Shipped From – LEXINGTON, KY What is This Part? This part attaches to the top of the transmission case and receives and holds in place the button of the shift lever. This housing is drilled for the 12mm Locating Bolt NOTE: If you are installing this...